Nilfisk Sopra 260 RRC Instrucciones De Uso página 33

PLEASE READ THESE ESSENTIAL INSTRUCTIONS
These Central Vacuum Cleaners is designed, developed and rigorously tested to function effi ciently and safely when
properly maintained and used in accordance with the following instructions. These instructions have been prepared for
your safety and must be followed.
CAUTION - This machine MUST NOT be used in explosive or infl ammable atmospheres or where such atmospheres
are likely to be produced by the presence of volatile liquid or infl ammable gas or vapour.
CAUTION - In no circumstances should the power supply cord be wrapped around fi ngers or any part of the operators
person.
CAUTION - The electrical supply plug must not be subjected to undue stress by pulling on the power supply cord.
CAUTION - This Central vacuum cleaner is to be placed in dry areas only, the machine should not be placed in areas
were the temperature goes higher than 40
Your machine must only be connected to an electrical supply of the same voltage and frequency indicated on the rating
plate. Ensure that the plug fi tted to the end of the power supply cord is suitable for your supply socket. If not, consult a
qualifi ed electrician. The electrical installation from which the supply is drawn must be maintained to current Institute of
Electrical Engineers wiring regulations.
REGULAR SERVICING AND INSPECTION of your machine must be carried out by suitable qualifi ed personnel in accord-
ance with relevant legislation and regulations. In particular, electrical tests for earth continuty, insulation resistance and
condition of the fl exible cord should be checked frequently. In the event of any defect the machine MUST be withdrawn
from service, completely checked and repaired. Trained Service Engineers will be pleased to carry out on site servicing
on a regular or as requested basis, to ensure the continuing safety and effi ciency of your machine.
ELECTRICAL CONNECTION
(Only applicable to U.K)
DOUBLE-INSULATED MACHINES IMPORTANT
240 volt 50 Hz. machines are fi tted with a 13 amp. 3 pin moulded plug. A replacement fuse must be in accordance to BS
1362, Asta approved and have a value of 13 amp.
Important: • The fuse cover must be refi tted after changing the fuse.
• In the event of the fuse cover being misplaced, the plug must not be used until the fuse cover is re
placed.
• Ensure that the replacement fuse cover is the same color as the insert or, as the colour
embossed in words on the base of the plug.
• For replacement fuse covers please contact your local electrical store.
If the available socket outlet is not suitable for the plug supplied, the plug must be cut off and an appropriate plug fi tted.
The plug that is cut off MUST BE DESTROYED for safety reasons before being disposed of. Machines built for other
voltages and frequencies are not normally supplied with a fi tted plug. If it is necessary to fi t a plug, the wires in this power
supply cord are coloured in accordance with the following code:
To connect the new plug:
If using a three-pin plug, do not make any connection to the terminal in the plug which is marked with the letter 'E' or by
the safety earth symbol or coloured green or green and yellow. This machine is double-insulated and no earth connection
is necessary. The wire which is coloured blue must be connected to the terminal in the plug which is marked with the letter
'N' or is coloured black or blue. The wire which is coloured brown must be connected to the terminal in the plug which is
marked with the letter 'L' or is coloured red or brown. If the plug to be fi tted does not conform to the above notation then
consult a qualifi ed electrician.
This appliance conforms with EC-Instructions 2004/108/EC, 2006/95/EC.
(Only applicable to UK) (Only applicable to UK)
o
C.
BLUE-NEUTRAL
BROWN-LIVE
33