Filter And Dust Bags - Bronze/Sopra 100; Replacing The Dust Bag; Replacing / Cleaning The Fi Lter - Nilfisk Sopra 260 RRC Instrucciones De Uso

4 Filter and dust bags - Bronze/Sopra 100

4.1 Replacing the dust bag

The central vacuum cleaner is fi tted with a dust bag as standard;
never vacuum without a dust bag installed.
Grasp the edge of the lid and pull upwards to open it, Fig. 10.
Replacing the dust bag: Remove the old dust bag by turning
the cardboard stiffener to the right or left so that the raised part
of the inlet is in line with the opening in the card. Now slide the
bag off the bag nozzle.
Fit the new dust bag as follows: Push the opening in the
cardboard over the elevation on the inlet and pull on the new
bag. Turn the cardboard to lock the bag in place. NB! Turn the
edges of the dust bag down into the container. This is to avoid
damaging the bag with the lid.
The cardboard stiffener locks the bag in place when you twist it
as shown in Fig. 11 above.
The opening in the card must line up and slide over the elevation
on the inlet before you twist the cardboard stiffener to lock it.
36
Fig. 10
Fig. 11
Fig. 12
4.2 Replacing / cleaning the fi lter
Open the lid and take out the dust bag as described earlier.
The fi lter sits at the bottom of the container around the motor
housing. Never use the central vacuum cleaner without a
fi lter installed.
Pull the fi lter out of the container, Fig. 12. The fi lter can be
cleaned by shaking it or washing it in water.
If you wash the fi lter, you must let it dry completely before
refi tting it.
Take the cleaned/new fi lter and place it in the bottom of the
container. Press the outer edge of the fi lter down against the
sides of the container so that the fi lter bulges up slightly. Then
push the fi lter down into place. Make sure the fi lter is packed in
tightly against the motor housing, Fig. 13. Reinstall the dust bag
and replace the lid. Check that the lid is fi rmly secured.
Motor housing
Filter
Fig. 13
Filter