PREPARING JUICE
1.
Prepare the appliance as descri-
bed in the section "Preparing the
appliance for operation".
2.
Remove the tamper from the fill
opening.
3.
Set the selection switch to the
desired speed.
Use level 1 for soft fruit, such as
grapes, melons, and pears, or soft
vegetables, such as cucumbers.
Use level 2 for hard fruits and
vegetables, such as apples and
carrots.
4.
Place the fruit and vegetable pie-
ces into the filling shaft and push
the pieces slowly down with the
tamper. The less pressure you
apply, the more juice you will
obtain.
5.
We recommend that you have the
appliance extract juice for a maxi-
mum time of one minute, and
then let it cool for one minute,
before running it again. After a
total of three cycles, the appli-
ance should cool for approx. 15
minutes, before you place it in
service again.
Caution: Never reach your
fingers or put foreign objects
into the filling shaft while the
juicer is in operation. Danger
of injury!
6.
If pieces of fruit or vegetables get
jammed and cannot be loosened
with the tamper, switch the appli-
ance off. Unplug the appliance
from the power supply and take it
apart to remove the piece of fruit
or vegetable that is causing the
26
block. Then reassemble the appli-
ance and continue processing.
7.
The juice will now run into the
juice pitcher.
8.
Ensure that the pomace container
is not over-filled. If the pomace
container is full, switch the appli-
ance off. Unplug the appliance
from the power supply and take
the appliance apart: First remove
the lid, then take out the sieve;
then remove the juice collection
tray and empty the pomace con-
tainer. Then reassemble the appli-
ance and continue processing.
9.
If the juice pitcher is full, switch
the appliance off by placing the
switch on "0", pour the juice into
another container and then conti-
nue processing.
10. Tip: The juice pitcher has a foam
separator. If you prefer foamy
juice, simply remove the lid from
the juice pitcher after extracting
the juice and then pour the juice.
However, during the juicing pro-
cess, the lid should be on the pit-
cher to prevent splashing.
11. When you have finished prepa-
ring juice, switch the switch to
"0" and unplug the plug from the
electrical outlet. We recommend
that you then immediately clean
the appliance.
12. Note: The appliance has an over-
heating protection circuit. If the
appliance should become too
warm in operation, the overhea-
ting protection circuit switches