Operating Instructions; Rf Lisa Combi - HumanTechnik lisa combi II Instrucciones De Servicio

Accessory:
telephone cable
Accessory: microphone cable
with 2.5 mm jack plug
Congratulations on purchasing your
RF lisa combi II . We hope it will give
you many years of reassuring opera-
tion. Please read through these ope-
rating instructions carefully. They tell
you how to set up the system correct-
ly and explain all the system's fea-
tures to you.
Included in the standard package
Please check if all following compo-
nents are included:
- RF lisa combi II
- Telephone cable, length 6 m
- Microphone cable, length 1 m
- 9 V block battery

- Operating Instructions

- Warranty card
If any parts are missing please imme-
diately contact your dealer or the
manufacturer directly.
Operating principle
A signalling system consists of at
least one transmitter and one recei-
ver. The RF lisa combi II picks up the
ringing signals from telephone and
doorbell through an electrical
connection. It converts these signals
into radio pulses (868.35 MHz) and
transmits them to the receiver without
the need for wires.
Special features
When a signal is detected, it is trans-
mitted for a total of 22 seconds. This
increases both the reliability and the
range of the system.
Setting up the system –
1. Inserting the battery
There is a battery compartment on
the back of the RF lisa combi II .
Open it by sliding the cover of the
battery compartment to the right of
the receiver using your thumb.
Connect a 9 V block battery to the
connector plug, place the battery
into the recess and close the recei ver
again. When the battery is connec-
ted, the receiving signals may be
triggered once.
English 9