Publicidad
Idiomas disponibles
Idiomas disponibles
Do not mount chains worn by more than one half of the
diameter of the wire, even if only one link is affected.
- Chains must always be mounted in pairs on an axle.
- Read the mouting instructions carefully. Non-obser-
vance of the mouting instructions may result in
malfunctions of the chains and damage to the car and
may increase the risk of accident.
- Before using the car always check if the chains have
been mounted correctly.
- After a short driving distance (aprox. 50 to 100 meters)
the perfect and centric fit of the chains has to be
checked. Retension chains if necessary.
- Tension the anti-skid-chains only as tight as necessary.
Excessive tensioning may cause damage to chain and
tire.
- Make sure that after the mounting no part of the chain
grazes parts of the vehicle.
- On a surface completely covered with snow the driving
speed should not exceed 50 km/h; drive considerably
slower if the road is partly free of snow.
- Avoid spinning of the chains. Increased wear would lead
to greater damage to the chain.
- Check condition and wear of the chains during travel (at
intervals of 20 km or after longer periods of driving on
roads free of snow).
- Repairs of damaged chains and modifications to suit a
different size should only be carried out by qualified
personnel.
- Keep anti-skid-chains in a dry place. Protect rubber ten-
sioner against chemical influence (fuel, acid, heat) and
check it regularly.
- Only use original spares for repairs.
Good luck on your trips without accident on the
snow-covered roads wishes you the Pewag
company, the producer and supplier of the
snow chains for the ·kodaAuto company.
The information on the technical data, design, equipment, materials, guar-
antees and outside appearance refer to the period when the mounting in-
structions are sent to print.
The manufacturer reserves the right to changes (including the change in
technical parameters with reference to the individual model measures).
Publicidad
