- 12 -
- open the ball clip (A) and let the chain fall onto the
ground.
- drive the vehicle slowly off the chains.
Warning against misuse
Our excellent product has been manufactured with
utmost care.
Legal regulations require that these warnings are
attached although many of them will seem self-evident to
you.
But always keep in mind that these instructions have to
be observed on any condition and that we will not
assume liability for any damage resulting, even in part,
from the non-observance of these instructions. By using
the anti-skid and tire protection chains, you and your staff
declare to have taken notice of and will observe these
warnings and that you will not assert any claims against
the manufacturer, importer or retailer in case of non-
observance.
Non-observance of the following instructions may cause
substantial damage to persons or property (road acci-
dents) with severe consequences.
- Anti-skid and tire protection chains shouid only be used
for mounting on vehicle tires. These chains as well as the
spare parts are case-hardened, thus being wear-resis-
tant, and must not be used for pulling, lifting or other
purposes.
- Only mount the chains on tires of the dimensions spe-
cified on the respective label of the package. Caints fit
new tires corresponding to the ETRTO standards moun-
ted on adequante rims. Retreaded tires are often larger
and the perfect fit of the chains has to be checked in each
case. If the chain does not fit perfectly it must not be
used. Check the inflation pressure according to the
instructions of the vehicle manufacturer. The air pressure
must not be reduced before the mounting and then
increased again as this could lead to damage (breakage,
cracks) of chain and tire due to overtension.
- Check the chains before use. If parts of the chain are
damaged or broken the chain must not be used.