J CONTROL PANEL
J
To prevent activating the control panel during cleaning,
unplug the range. Clean up splatters with a damp cloth
using a glass cleaner. Remove heavier soil with warm,
soapy water. Do not use abrasives of any kind.
J FRONT MANIFOLD PANEL AND
J
KNOBS
It is best to clean the manifold panel after each use
of the range. For cleaning, use a damp cloth and mild
soapy water or a 50/50 solution of vinegar and water.
For rinsing, use clean water and polish dry with a soft
cloth.
NOTE:
• Do not use abrasive cleansers, strong liquid cleaners,
plastic scouring pads or oven cleaners on the manifold
panel. Doing so will damage the finish.
• Do not try to bend the knobs by pulling them up or
down or by hanging a towel or other objects on them.
This can damage the gas valve shaft.
• The control knobs may be removed for easy cleaning.
• To clean the knobs, make sure that they are in the OFF
position and pull them straight off the stems.
• To replace the knobs, make sure the knob has the
OFF position centered at the top, and slide the knob
directly onto the stem.
NOTE: To prevent scratching, do not use abrasive
cleaners on any of these materials.
J OVEN DOOR
J
Do not hand clean the
oven door gasket
Hand clean the door
Do not hand clean the
oven door gasket
Hand clean the door
• Use soapy water to thoroughly clean the oven door.
Rinse well. DO NOT immerse the door in water.
• You may use a glass cleaner on the outside glass of the
oven door. DO NOT spray water or glass cleaner on
the door vents.
• DO NOT use oven cleaners, cleaning powders, or harsh
abrasive cleaning materials on the outside of the oven
door.
• DO NOT clean the oven door gasket. The oven door
gasket is made of a woven material that is essential for
a good seal. Care should be taken not to rub, damage,
or remove this gasket.
NOTE: Do not use cleaners or harsh abrasive cleaning
materials on the outside of the oven door. Doing so can
cause damage.
33
CARE AND CLEANING