Stihl FC 55 Manual De Instrucciones página 10

!
Warning!
To reduce the risk of fire or burn injury,
keep the area around the muffler clean.
Remove all debris such as pine needles,
branches or leaves.
!
Warning!
An improperly mounted or damaged
cylinder housing or a damaged/
deformed muffler shell may interfere
with the cooling effect of the catalytic
converter. To reduce the risk of fire or
burn injury, do not continue work with a
damaged or improperly mounted
cylinder housing or a damaged/
deformed muffler shell. Your catalytic
converter is furnished with screens
designed to reduce the risk of fire from
the emission of hot particles. Due to the
heat from the catalytic reaction, these
screens will normally stay clean and
need no service or maintenance. If you
experience loss of performance and you
suspect a clogged screen, have your
muffler maintained by a STIHL Servicing
Dealer.
Working Conditions
Operate and start your edger only
outdoors in a well ventilated area.
FC 55
!
Warning!
Your edger produces toxic
exhaust fumes as soon as
the engine is running.
These gases (e.g.
carbonmonoxide) may be
colorless and odorless. To
reduce the risk of serious or fatal injury
from inhaling toxic fumes, never run the
edger indoors or in poorly ventilated
locations.
!
Warning!
Use of this product can generate dust
and fumes containing chemicals known
to cause respiratory disease, cancer,
birth defects, or other reproductive
harm. If you are unfamiliar with the risks
associated with the particular dust or
fume at issue, consult your employer,
governmental agencies such as OSHA
and NIOSH and other sources on
hazardous materials. California and
some other authorities, for instance,
have published lists of substances
known to cause cancer, reproductive
toxicity, etc.
English / USA
Control dust and fumes at the source
where possible. In this regard use good
work practices and follow the
recommendations of OSHA/NIOSH and
occupational and trade associations.
When the inhalation of toxic dust and
fumes cannot be eliminated, the
operator and any bystanders should
always wear a respirator approved by
NIOSH/MSHA for the type of dust and /
or fumes encountered.
Operate the edger under good visibility
and daylight conditions only. Work
carefully.
Always hold the edger firmly with both
hands. Wrap your fingers tightly around
the handles, keeping the handles
cradled between your thumb and
forefinger. Keep your hands in this
position to have your edger under
control at all times.
9