JVC XV-N5SL Manual De Instrucciones página 65

PICTURE
Symptom
No picture is displayed on the monitor.
The picture is noisy or blurred.
The picture does not fit the television
screen.
The upper and lower parts of the
preference display are cut off when using
wide-aspect TV.
AUDIO
Symptom
No audio is reproduced.
No audio is reproduced when playing back
a DVD disc recorded with high sampling
frequency (88.2 kHz or more) linear PCM
audio using the DIGITAL OUT jack.
Audio volume is low when playing back
with the unit, compared with the TV or
VCR.
Sound is distorted or noise is generated.
Possible cause
Connection of video cable is incorrect.
Input selection of TV is incorrect.
Disc is not playable.
The unit is connected to a VCR directly and
the copyguard function is activated.
With some discs, the picture may be
" "
blurred when STILL MODE is set to
" " " ."
FRAME or AUTO
MONITOR TYPE is not set correctly.
TV settings are incorrect.
It depends on the setting on the TV.
Possible cause
Connection is incorrect.
Input selection of amplifier is incorrect.
Audio signal is not emitted from the unit's
DIGITAL OUT (see page 51).
The audio level recorded on a DVD VIDEO
is lower compared with a TV broadcast.
Disc is dirty.
Additional information
Remedy
Connect the cable correctly.
Select correctly.
Use a playable disc (see page 4).
Connect the unit so that the picture signal
flows directly to the TV.
" " " "
Set STILL MODE to FIELD
51).
Select monitor type correctly (see page 50).
Set the television correctly.
Adjust the TV screen using the controls on
the TV.
Remedy
Check the connection.
Select correctly.
Use AUDIO OUT when playing back such
discs.
Turn up the volume of the TV or amplifier/
receiver.
Remember to turn the volume back down
before switching back to a TV broadcast to
prevent a sudden burst of high-volume
sound.
Wipe the disc surface (see page 5).
English
(see page
61