Activating Crossover Network; Setting The Sound Modes-Sel - JVC KD-SH1000 Manual De Instrucciones

Activating crossover network

By activating crossover network, you can
allocate different frequency range of sound
signals to different speakers to match their
characteristic.
If you have installed the 3-way network
speaker system in the car, make sure of the
following:
• Before using the system, activate crossover
network and preset the appropriate cutoff
frequencies for HPF/LPF (especially
for HPF); otherwise, it may damage the
speakers.
• For 3-way network speaker system, see
Installation/Connection Manual (separate
volume).
You cannot perform other operations until you
finish the following procedure.
While the power is turned off...
~
Ÿ
!
• To cancel the procedure, press and
hold POWER/ATT/ENTER. The power
turns off.
⁄
Finish the procedure.
18
• indicator
lights up (in sequence
with other indicators).
To cancel Crossover, repeat the same
procedure. Make sure that "X-Over Off OK?"
appears on the display.
• indicator goes off.
Setting the sound modes—SEL
You can adjust the sound characteristics to your
preference.
~
Enter the SEL menu (see page 4).
Ÿ
Select a setting item.
* Appears only when crossover network is
activated (see left column).
When selecting "Fad/Bal," "X-Over," or
"S.woofer," press POWER/ATT/ENTER
to enter its submenu.
!
Adjust the selected setting item.
(See the following for details.)
• To adjust other SEL settings, press
BACK. Then repeat steps Ÿ and !.
⁄
Finish the procedure.
To adjust fader and balance—Fad/Bal
•
Fad (fader)
Adjust the front and rear speaker balance.
•
Bal (balance)
Adjust the left and right speaker balance.