Product Introduction; Applications - Grundfos CIM 260 Instrucciones De Instalación Y Funcionamiento

3. Product introduction

3.1 Applications

The CIM 260 or CIM 280 cellular module (CIM =
Communication Interface Module) enable data
transmission between a cellular network and a
Grundfos product.
The CIM 260 communicates using Modbus TCP via
cellular data transmission to a SCADA system or
SMS communication to mobile phones.
The CIM 280 communicates via cellular network to
Grundfos iSolution Cloud (requires a Grundfos
contract).
In the following, "Grundfos product" means one or
more Grundfos products, depending on the actual
application.
The CIM 260 and CIM 280 cellular module make it
possible to control and monitor a Grundfos product in
several ways:
• From a SCADA system via a data connection.
• From a SCADA system via a call-up connection.
• From a mobile phone via SMS messages.
See the manual "CIM 260 SMS commands".
• From Grundfos Remote Management or
Grundfos iSolution Cloud (GiC) where control
takes place via a central server. This is not
described in this booklet. See the installation and
operating instructions for Grundfos Remote
Management.
The CIM 260 or CIM 280 is supplied separately and
must be fitted in the product to be communicated
with or in a CIU unit (CIU = Communication Interface
Unit).
Retrofitting of the CIM 260 or CIM 280 is described
in the installation and operating instructions of the
Grundfos product.
3.1.1 CIM 260 or CIM 280 cellular module
1
2 3
CIM 260 or CIM 280 cellular module
Fig. 6
Pos. Designation Description
1 Battery socket
2 SIM card holder
Secondary SMA connection
3
for cellular antenna*
Primary SMA connection for
cellular antenna.
4
This antenna must always
be connected.
Yellow and green status LED
5 LED1
for cellular communication.
Red and green status LED
for internal communication
6 LED2 between the CIM 260 or CIM
280 and the Grundfos
product.
For CIM 260:
To reset to factory settings,
press and hold for at least 5
seconds.
For CIM 280:
7 SW1
To reset the CIM 280, press
and hold for 1 second.
To reset to factory settings,
press and hold for at least 5
seconds.
* Only use this antenna connection if required by
the telecom company.
7
4 5 6
7