Product Introduction; Applications - Grundfos CIM 260 Instrucciones De Instalación Y Funcionamiento

3. Product introduction

3.1 Applications

CIM 260 or CIM 280 cellular module (CIM =
Communication Interface Module) enable data
transmission between a cellular network and a
Grundfos product.
CIM 260 communicates using Modbus TCP via
cellular data transmission to a SCADA system or
SMS communication to mobile phones.
CIM 280 communicates via cellular network to the
related cloud, for example, Grundfos iSolutions
Cloud, (requires a Grundfos contract).
In the following, "Grundfos product" means one or
more Grundfos products, depending on the actual
application.
CIM 260 and CIM 280 cellular module make it
possible to control and monitor a Grundfos product in
several ways:
• From a SCADA system via a data connection.
• From a mobile phone via SMS messages.
See the manual "CIM 260 SMS commands".
• From Grundfos iSolutions Cloud or the related
cloud where control takes place via a central
server. This is not described in this document.
CIM 260 or CIM 280 is supplied separately and must
be fitted in the product to be communicated with or in
a CIU unit (CIU = Communication Interface Unit).
Retrofitting of CIM 260 or CIM 280 is described in
the installation and operating instructions of the
Grundfos product.
If you want CIM 280 to connect to another
cloud than Grundfos iSolutions Cloud, for
example, Grundfos Remote Management,
it can take 3-4 minutes until the interface
reconnects at first communication process.
8
3.1.1 CIM 260 or CIM 280 cellular module
1
2 3
Fig. 6 CIM 260 or CIM 280 cellular module
Pos. Designation Description
1 Battery socket
2 SIM card holder
Secondary SMA connection
3
for cellular antenna*
Primary SMA connection for
cellular antenna.
4
This antenna must always
be connected.
Yellow and green status LED
5 LED1
for cellular communication.
Red and green status LED
for internal communication
6 LED2 between CIM 260 or CIM
280 and the Grundfos
product.
For CIM 260:
To reset to factory settings,
press and hold for at least 5
seconds.
For CIM 280:
7 SW1
To reset CIM 280, press and
hold for 1 second.
To reset to factory settings,
press and hold for at least 5
seconds.
* Only use this antenna connection if required by
the telecom company.
7
4 5 6