OP TUBOMATIC H46 Manual De Uso página 24

OP S.r.l.
Via Serpente 97 25131 Brescia Italia Tel. +39.030.3580401 Fax. +39.030.3580838
________________________________________________________________________________________________
Briefly, the machine consists of:
A metal frame that supports the hand pump and the crimping unit.
•
A crimping unit consisting of a hydraulic cylinder with tapered piston, in contact with
•
dies in special steel which apply an even radial force to the fitting to be crimped.
A drive consisting of a single-acting high pressure hand pump, with oil tank and drain
•
tap.
The Operation and Maintenance Manual appendix contains the technical specifications
•
and working instructions for the pump. For spare parts, please contact your local
distributor (see the enclosed list ) in order to accelerate their replacement.
The return of the piston is ensured by return springs.
•
Safety systems providing protection against the risks involved in the process.
•
TECHNICAL/DIMENSIONAL DATA
E
Crimping power (without friction)
N
Max. opening (mm)
G
Max. dies opening (mm)*
L
Crimping range (mm)
I
Working capacity
S
Max. dies length
H
Max. dimensions (LxDxH in mm)
Weight
Max. operating pressure
Tank capacity
Controls
Max. force applied to pump lever
Cylinder oil volume
TECHNICAL/DIMENSIONAL DATA
Crimping power (without friction)
Max. opening (mm)
Max. dies opening (mm)*
Crimping range (mm)
Working capacity
Max. dies length
Max. dimensions (LxDxH in mm)
Weight
Max. operating pressure
Controls
Max. force applied to pump lever
Cylinder oil volume
*Add this value to the minimum crimping diameter of the die you wish
to use in order to obtain the maximum die opening.
TUBOMATIC H46
100 ton
59 mm
+ 20 mm
10 – 46 mm
1"
65 mm
300x390x280
32 kg
700bar
0.7dm³
Manual
30 Kg at 700 bar
0.3 l
TUBOMATIC H46/E
100 ton
59 mm
+ 20 mm
10 – 46 mm
1"
65 mm
300x345x330
26 kg
700bar
Manual
30 Kg at 700 bar
0.3 l
24