Recalibrating Your Oven Temperature - Sears Kenmore 790.46992 Manual De Uso Y Cuidado

General
Cleaning
FEATURE OVERVIEW
• To Remove and
Replace the Storage
Drawer
_Roller Storage
_. Roller
Frame
To Remove and Replace the Storage Drawer
Use the storage drawer for storing cooking utensils. The drawer can de removed to facilitate
cleaning under the range. Use care when handling the drawer.
To open the storage drawer, push the drawer in gently and it will spring open. To close, push
the drawer until you hear a click, which indicates that the spring is compressed, and the drawer
is closed.
To remove the drawer:
1. Pull empty drawer out to the roller guide stop.
2. Tilt the drawer up and pull it out over the rollers.
To replace the drawer:
1. Insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow the rollers to clear the roller guide
stop, and push in.
Recalibrating
Your Oven
Temperature
Your oven thermostat has been precisely set at the factory. This setting may differ from your
previous oven, however, so your recipe times may not give you the results you expect. If you
think that the oven is cooking too hot or cool for your recipe times, you can adjust the
thermostat so that the oven cooks hotter or cooler than the temperature displayed.
To Adjust Oven Temperature:
1. Push the BAKE pad _.
2. Set the temperature to 550°F (287°C) by pushing and holding the UP ARROW pad ^.
3. Within 2 seconds, push and hold the BAKE pad _ until the special 2 digit display
appears. Releasethe BAKE pad _. The display now indicates the amount of degrees
offset between the original factory temperature setting and the current temperature
setting. If the oven control has the original factory calibration, the display will read "00."
4. The temperature can now be adjusted up or down 35°F (17°C), in 5°F (1°C) steps by
pushing and holding the LIP ^ or DOWN ARROW pad v. Adjust until the desired
amount of degrees offset appears in the display. When lowering the oven temperature, a
minus sign (-) will appear before the number to indicate that the oven will be cooler by
the displayed amount of degrees.
5. When you have made the desired adjustment, push the CANCEL OFF pad _ to go
back to the time of day display.
Note: The adjustment made will not change the self-cleaning temperature.
24