Changing Oven Light; Recalibrating Your Oven Temperature - Sears Kenmore 790.4710 Serie Manual De Uso Y Cuidado

Changing Oven Light

Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the
oven light on during a self-cleaning cycle. High temperature will reduce lamp life.
On some models an interior oven light will turn on automatically when the oven is opened.
The oven light may be turned on when the door is closed by using the oven light switch located on the Electronic Oven
control.
The oven light bulb is covered with a glass shield held in place by a wire holder. THIS GLASS SHIELD MUST ALWAYS BE IN
PLACE WHEN THE OVEN IS IN USE.

Recalibrating Your Oven Temperature

Your oven thermostat has been precisely set at the factory. This setting may differ from your previous oven, however, so your
recipe times may not give you the results you expect. If you think that the oven is cooking too hot or cool for your recipe times,
you can adjust the thermostat so that the oven cooks hotter or cooler than the temperature displayed.
To Adjust Oven Temperature:
1. Push the BAKE pad
2. Set the temperature to 550°F (287°C) by pushing and holding the UP ARROW pad
3. Within 2 seconds, push and hold the BAKE pad
The display now indicates the amount of degrees offset between the original factory temperature setting and the current
temperature setting. If the oven control has the original factory calibration, the display will read "00."
4. The temperature can now be adjusted up or down 35°F (17°C), in 5°F (1°C) steps by pushing and holding the UP
DOWN ARROW pad
oven temperature, a minus sign (-) will appear before the number to indicate that the oven will be cooler by the displayed
amount of degrees.
5. When you have made the desired adjustment, push the CANCEL OFF pad
Note: The adjustment made will not change the self-cleaning temperature.
To Replace the Light Bulb:
BE SURE OVEN IS COOL
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and
be sure to replace glass shield.
.
. Adjust until the desired amount of degrees offset appears in the display. When lowering the
until the special 2 digit display appears. Release the BAKE pad
27
.
to go back to the time of day display.
.
or