Verify Anti-Tip Bracket Is Installed And Engaged; Remove/Replace Drawer; Oven Door - Sears Kenmore Elite 66495223710 Instrucciones De Instalación

4. Attach terminal lugs to line 1 (black), neutral (white), and
line 2 (red) wires. Loosen (do not remove) the setscrew on
the front of the terminal lug and insert exposed wire end
through bottom of terminal lugs. Securely tighten setscrew
to torque as shown in the following Bare Wire Torque
Specifications chart.
A
B
C
A. 10-32 hex nut
B. Line 2 (red) wire
C. Bare (green)
ground wire
Bare Wire Torque Specifications
Attaching terminal lugs to the terminal block - 20 lbs-in.
(2.3 N-m)
Wire Awg
8 gauge copper
6 gauge aluminum
5. Use a hex or Phillips screwdriver to connect the bare (green)
ground wire to the range with the ground-link screw and
ground-link section. The ground wire must be attached
over the ground-link section and must not contact any
other terminal.
6. Use 3 / " (1.0 cm) nut driver to connect the neutral (white)
8
wire to the center terminal block post with 1 of the 10-32
hex nuts.
C
D
A. Terminal lug
B. Setscrew
C. Line 2 (red) wire
D. Neutral (white) wire
E. Line 1 (black) wire
7. Connect line 2 (red) and line 1 (black) wires to the outer
terminal block posts with 10-32 hex nuts.
8. Firmly tighten hex nuts.
IMPORTANT: Verify the tightness of the hex nuts.
9. Replace lower access cover.
G
F
D
E
D. Ground-link screw
E. Neutral (white) wire
F. Line 1 (black) wire
G. Terminal lug
Torque
25 lbs-in. (2.8 N-m)
35 lbs-in. (4.0 N-m)
A
B
E
Verify Anti-Tip Bracket
Is Installed and Engaged
1. Slide range into final location, making sure rear leveling leg
slides into anti-tip bracket.
2. Remove the premium storage drawer. See the "Remove/
Replace Drawer" section.
3. Use a flashlight to look underneath the bottom of
the range.
4. Visually check that the rear range foot is inserted into the
slot of the anti-tip bracket.

Remove/Replace Drawer

Remove all items from inside the storage drawer, and then
allow the range to cool completely before attempting to
remove the drawer.
To Remove:
1. Open the drawer to its fully open position.
2. Raise the front edge, and then lift out.
To Replace:
1. Align the forward drawer notches with the notches in the
drawer rails on both sides. Place the rear alignment tabs
into the drawer rails on both sides.
2. Push the drawer in all the way.
3. Gently open and close the drawer to ensure it is seated
properly on the rails on both sides.

Oven Door

For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven
is off and cool. Then, follow these instructions. The oven door
is heavy.
To Remove:
1. Open oven door all the way.
2. Pinch the hinge latch between 2 fingers and pull forward.
Repeat on other side of oven door.
A. Hinge latch
3. Close the oven door as far as it will shut.
A
13