Acknowledging Errors - salmson SIE Serie Instalacion Y Puesta En Servicio

Classification No.
Electronics E070
errors
E071
E072
E076
E077
E096
E097
E098
11.3

Acknowledging errors

General
6.0.0.0
E000
6.0.0.0
10
1/1
Fig. 41: Navigation in case of error
Installation and operating instructions SIE-DIE-PBE
Error
Internal communica-
tion error (SPI)
EEPROM error
Power section/fre-
quency converter
Internal transformer
defective
24 V operating voltage
for sensor defective
Infobyte not set
Flexpump data record
missing
Flexpump data record
invalid
E000
5.0.0.0
S
Cause Remedy
Internal electronics error Ask After-Sales.
Internal electronics error Ask After-Sales.
Internal electronics error Ask After-Sales.
Internal electronics error Ask After-Sales.
Sensor defective or con- Check differential pressure
nected incorrectly sensor connection
Internal electronics error Ask After-Sales.
Internal electronics error Ask After-Sales.
Internal electronics error Ask After-Sales.
In the event of an error, the error page is displayed instead of the sta-
tus page.
In this case, the following procedure can generally be used for naviga-
tion (Fig. 41):
• To change to the menu mode, press the red button.
Menu number <6.0.0.0> flashes on the display.
By turning the red button, it is possible to navigate in the menu as
usual.
• Press the red button.
Menu number <6.0.0.0> appears steady on the display.
On the units display, the current incidence (x) as well as the maximum
incidence of the error (y) are displayed in the format 'x/y'.
Until the error can be acknowledged, pressing the red button again
will cause a return to menu mode.
NOTE:
A 30-second time-out causes the display to revert to the status page
or error page.
NOTE:
Every error number has its own error meter, which counts the inci-
dence of the error within the last 24 hours and is reset after manual
acknowledgement, 24-hour continuous "mains On" or a new
"mains On".
English
Error type
HV AC
A A
A A
A A
A A
A A
A A
A A
A A
99