Tm (Rapid Station Test Routine); Raster Tm Operation; Beginning The Raster - Rain Bird ESP-MC Serie Manual De Operación

Rain Bird RASTER
RASTER TM Operation
Use the following procedure to perform the
RASTER TM on the master valves and all other
controller station valves.

Beginning the RASTER

1. Turn the Programming Dial to "OFF."
2. Press and release the L/ON
at the same time.
3. The display will look like the illustration below.
8
(Rapid Station Test Routine),
TM
TM
and M/OFF
continued
4. Press the "MAN START/ADV"
RASTER TM .
5. The display shows "TEST IO" and the indicator
lights on the front panel flash once as the
RASTER TM confirms the proper operation of the
controller's front panel lights.
NOTE: If the front panel is not connected to the
output board or the controller is disconnected
from the main power the display will show the
message "NO OUT."
The RASTER TM then automatically begins the test
on the controller's master valves and each station
valve, beginning with the master valve 1.
to begin the