SATA jet 1000 ROB RP Instrucciones De Servicio página 421

■ Adjust required material flow rate (see
Chap. 9.2).
10.2. Replace air distribution
ring
Perform all work steps described
in the Chapter Replace nozzle set
before and after replacing air distri-
bution ring (see Chap. 10.1).
Remove air distribution ring
Notice!
The air distribution ring is lodged
tightly in the nozzle head. Use of
too much force can damage the
nozzle head. Slipping with the
SATA extraction tool can lead to
injury.
→ Wear work gloves.
→ Always use SATA extraction
tool pointing away from your
body.
→ Pull air distribution ring evenly
out of nozzle head.
■ Perform 'Disassemble nozzle set'
work steps (see Chap. 10.1).
■ Pull out air distribution ring [9-1] using
SATA extraction tool [9-2].
■ Check sealing surfaces for damage
and contamination, clean or replace
as required.
Install new air distribution ring
■ Place air distribution ring [10-3] in to
nozzle head [10-2]. Ensure that the
lug at the bottom of the air distribution
ring is aligned properly [10-1].
Operating Instructions for SATA ROB Automatic Guns
■ Press air distribution ring in evenly.
■ Perform 'Install new nozzle set' work
10.3. Replace paint needle
If both paint needle seal retainers
are damaged, material can es-
cape from the gun body inspec-
tion hole [1-11].
→ Replace paint needle seal re-
tainer immediately.
Remove paint needle seal retainer
■ Unscrew and remove regulator
■ Unscrew and remove end cap [11-1].
■ Remove spring [11-2].
■ Remove paint needle [11-3].
■ Unscrew and remove four machine
■ Remove the four lock washers [11-6]
■ Remove nozzle head [11-5] from gun
Material side [12]
■ Unscrew seal retainer [12-2] from
Air side [13]
■ Unscrew seal retainer [13-2] from gun
■ Check seal retainer for damage and
Install new paint needle seal retainer
steps (see Chap. 10.1).
seal retainer
Notice!
cap (for variants with material flow
control).
screws [11-7] with Allen wrench.
from the machine screws.
body [11-4].
nozzle head [12-1] with socket
wrench [12-3].
body [13-1] with screwdriver [13-3].
contamination, clean or replace as
required.
US
421