Instructions For Special Conditions - Omron SpotArm i-Q132 Manual De Instrucciones

HEM-1010-E_[D].book 31 ページ ２０１１年１１月１５日 火曜日 午後７時３５分
3.4

Instructions for Special Conditions

If your systolic pressure is known to be more than 170 mmHg or if you
failed to measure blood pressure repeatedly, perform the following
steps.
1.
Place your arm through the arm cuff
and press the O/I button to turn the
power on.
2.
Press the user ID selection button
to select your user ID.
3.
Press and hold the START/STOP button until the cuff inflates
30 to 40 mmHg higher than your suspected systolic pressure.
Note: You cannot inflate the cuff above 299 mmHg. (An error
will be displayed if you try to inflate the cuff above
299 mmHg.)
4.
Release the START/STOP button when the cuff has been
inflated to the desired pressure.
The cuff starts to deflate and measurement starts.
5.
The rest of the procedure is the same as for normal
measurement. Refer to Chapter 3.3.
Note: Do not apply more pressure than necessary.
3. Using the Unit
EN
31