Emission Levels; Technical Data - Festool T 15+3 Li Manual De Instrucciones

T 15+3 Li, T 18+3 Li
GB
should either become damaged, in order to avoid
a hazard, have them replaced by an authorised
after-sales service workshop.
– Always pull the mains plug out of the socket
when the charger is not in use.
2.4

Emission levels

Levels determined in accordance with EN 60745 are
typically:
Sound pressure level
Sound power level
Uncertainty
Wear ear protection.
Vibration emission value a
directions) and uncertainty K measured in accor-
dance with EN 60745:
Vibration emission value a
directions) and uncertainty K measured in accor-
dance with EN 60745:
Drilling in metal
Screwing
4

Technical data

Cordless drill
Motor voltage
Idle engine speed*
Max. torque
Adjustable torque**
Chuck clamping range
Drill diameter max.
Tool holder in drill spindle
Weight without battery pack with Centrotec
* Speed specifications with fully charged battery pack.
** The maximum speed is reduced in the lower torque stages.

Further technical data on the charger and battery packs can be found on page 6.
14
L = 65 dB(A)
PA
L = 76 dB(A)
WA
K = 3 dB
(vector sum for three
h
(vector sum for three
h
a < 2,5 m/s
h
K = 1,5 m/s
a < 2,5 m/s
h
K = 1,5 m/s
Soft material (wood)
Hard material (metal)
The specified emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during
operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with other
insertion tools or if not maintained adequately. Take
note of idling and downtimes of machine!
3 Intended use
Cordless drill suitable for
– drilling in metal, wood, plastic and similar mate-
rials,
– inserting and tightening screws
– use with Festool batteries BPC and BPS of the
same voltage.
Charger TCL 3 suitable for
– charging Festool battery packs: BP, BPS and
BPC (NiMH, NiCd, li-ion are recognised automat-
2
ically.)
2
– indoor use only.
2
The user is liable for improper or non-in-
2
tended use; this also includes continuous in-
dustrial operation.
1st gear
2nd gear
1st gear
2nd gear
Wood
Metal
T 15+3 Li T 18+3 Li
14,4 - 15,6 V
-1
0 - 450 min
-1
0 - 1500 min
27 Nm 30 Nm
40 Nm 45 Nm
0,5 - 8 Nm
0,5 - 8 Nm
1,5 - 13 mm
35 mm 45 mm
16 mm 16 mm
1/4 '' 1/4 ''
1,0 kg 1,0 kg
18 V