Machine Features - Festool T 15+3 Li Manual De Instrucciones

5

Machine features

[1-1] Buttons for releasing the battery pack
[1-2] Bit store
[1-3] On/Off switch
[1-4] Right/left switch
[1-5] LED lamp
[1-6] Gear switch
[1-7] Drilling symbol
[1-8] Screwdriving symbol
[1-9] Drilling/Fastening selector switch
[1-10] Capacity display
[1-11] Belt clip
[1-12] Torque thumbwheel
[1-13] Insulated gripping surfaces (grey shaded
area)
[2-1] Battery blanking plug
[3-1] LED-Display
[3-2] Cable holder
[3B] Wall mount for charger
The specified illustrations appear at the beginning
of the Operating Instructions.
6 Operation
6.1 Charger cable holder [3-2]
Unwind the cable completely from the recess
before using the charger.
6.2 Changing the battery pack [2]

Battery pack is ready for use immediately upon
delivery and can be charged at any time.

When using NiMH or NiCd battery packs, the va-
cant opening can be closed with the blanking
plug [2-1].
The capacity display [1-10] automatically displays
the charge state of the battery pack [1-3] when the
ON/OFF switch is actuated:
(not NiCd- and NiMH-battery packs)
70 - 100 %
40 - 70 %
15 - 40 %
< 15 %
Recommendation: Charge bat-
tery pack before further use.
6.3 Charging the battery pack [3A]
The LED [3-1] on the charger indicates the respec-
tive operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashes quickly
Battery pack is charged to maxi-
mum capacity.
LED green - flashes slowly
Battery pack is charged with
reduced current. Li-ion is
charged to > 90 %.
LED green - lit continuously
Charging is complete or is not
restarted as current charge sta-
tus is greater than 90%.
LED red - flashes
General fault indication, e.g.
incomplete contact, short circuit,
defective battery pack, etc.
LED red - lit continuously
Battery temperature is outside
the permitted range.
7 Settings
CAUTION
Risk of injury

Always switch off the power tool before adjusting
settings!
7.1 Changing direction of rotation [1-4]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rotation
7.2 Changing gear [1-6]
• Gear switch forwards (digit 1 visible) = 1st gear
• Gear switch to rear (digit 2 visible) = 2nd gear
7.3 Fastening
Adjust the switch so that its marking [1-9] faces the
screw symbol [1-8].
Adjust the torque accordingly at the torque wheel
[1-12].
Position 1 = low torque
Position 25 = high torque
An acoustic signal sounds when the preset torque
is reached and the machine then switches off. You
must release and press the ON/OFF switch [1-3]
T 15+3 Li, T 18+3 Li
GB
15