Tool Holder, Attachments; Service And Maintenance; Working With The Power Tool - Festool T 15+3 Li Manual De Instrucciones

T 15+3 Li, T 18+3 Li
GB
again to start the machine.
7.4 Drilling
Adjust the switch so that its marking [1-9] faces
the drilling symbol [1-7] = maximum torque.
8

Tool holder, attachments

WARNING
Risk of injury

Always disconnect the battery pack before per-
forming any type of work on the machine!
CAUTION
Hot and sharp tools
Risk of injury

Do not use insert tools that are blunt or defective.

Wear protective gloves.
8.1 CENTROTEC tool chuck [4]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTRO-
TEC tool chucks.
8.2 Chuck BF-FX [5]
For clamping drill bits and bits with max. shaft di-
ameter of 13 mm.
Clamp tool centrally in the chuck.
8.3 Angle attachment DD-AS [6]
Drilling and screwing at right angle to machine
(partly as an accessory).
8.4 Eccentric attachment DD-ES [7]
Screwdriving near edges with bits according to ISO
1173 (partly as accessory).
8.5 Tool holder in the drill spindle [8]
Bits can be inserted directly into the hexagon sock-
et holder of the drill spindle.
9

Working with the power tool

WARNING
Risk of injury

Always secure the workpiece in such a manner
that it cannot move while being machined.
16
9.1 On/Off switch [1-3]
Press = ON, release = OFF

The speed of the machine depends on how far
the on/off switch is pressed in.
The LED bulb [1-5] lights up when the ON/OFF
switch is pressed [1-3].
9.2 Bit store [1-2]
Magnetic, for storing bits and bit holders.
9.3 Acoustic warning signals
Acoustic warning signals sound and the machine
switches off in the following operating states:
Battery flat or machine over-
loaded.
– Change the battery.
– Place the machine under reduced
stress.
Machine is overheating.
– You must allow the machine to
cool before using again.
LiIon battery pack is faulty or has
overheated.
– Once the battery pack has cooled,
perform a functional check using
the charger.

10 Service and maintenance

WARNING
Risk of injury, electric shock

Always disconnect the battery pack from the
machine before any maintenance or care work!

All maintenance and repair work which requires
the motor housing to be opened, must only be
carried out by an authorised service workshop.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
EKAT
Use only original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1
Note the following information:
– Keep the ventilation slits on the machine free and