WAGNER CONTROL PRO 190 Manual Del Propietário página 20

CLEANUP - CONTINUED
5.
Point the spray gun at the side of a waste container.
Ground the gun against the side of a metal waste
container if flushing with mineral spirits.
While squeezing the trigger, turn the pressure control knob to
'2', and turn the PRIME/SPRAY knob to SPRAY.
6.
Continue squeezing the trigger until fluid is coming out clear.
You may need to get new cleaning solution.
7.
Perform Pressure Relief Procedure, page 10.
8.
Remove the inlet filter by pulling if off the suction tube. Clean
by hand using a soft-bristled brush.
Remove the tip guard and spray tip from the cleaning solution.
Clean by hand using a soft bristled brush.
Make sure the opening in the black housing on
i
the suction tube that the inlet filter attaches to is
completely clean and free from spray material.
9.
If you are using a spray gun with a filter, remove and clean the
spray gun filter (refer to Spraying Troubleshooting - Clean the
Spray Gun Filter instructions, page 16).
(Continued on the next page)
20
5
6
7
8
9
P. 16
EN EN
SPRAY
PRIME
d
e
c