WAGNER CONTROL PRO 190 Manual Del Propietário página 21

CLEANUP - CONTINUED
10.
IMPORTANT STEP: Fill a bucket with warm, soapy water.
Following steps 5-7 in the "Spraying" section, spray at least one
gallon of warm, soapy water. This will ensure that the spray tip
will be completely clean for the next use.
11.
Perform Pressure Relief Procedure, page 10. Remove the
suction tube. Run water from a faucet through the tube to flush
out any remaining material. Do not reinstall the suction tube.
12.
Remove the spray tip assembly.
Repeat step 5 from above, continuing to squeeze the trigger
until no fluid comes from the gun (this will purge any remaining
water in the spray hose).
Turn PRIME/SPRAY knob to PRIME. Turn power OFF.
Do not allow the pump to run for more than one
minute without fluid.
Attention
13.
Reattach both the inlet filter and spray tip/tip guard assembly.
10
P. 12
11
12
13
EN
21