SPRAYING
Follow these steps to deliver spray material from the material
i
container to the spray gun.
YOU WILL NEED
•
Waste bucket
•
Scrap material / cardboard
•
Drop cloths to protect floors and furnishings from overspray
1.
Make sure the tip guard is removed. Point the spray gun into a separate
waste container. Unlock the spray gun trigger.
Squeeze and hold trigger for steps 2-3.
2.
Slowly turn the pressure control knob clockwise to setting '2'.
Turn the PRIME/SPRAY knob to SPRAY.
3.
Continue to squeeze trigger until the material is flowing freely through the
spray gun.
4.
Perform the Pressure Relief Procedure, page 10.
5.
Make sure the spray gun trigger is locked. Thread the spray tip guard
assembly onto the gun.
Tighten by hand.
6.
Make sure the spray tip is rotated forward to the spray position, with the
arrow on the tip facing forward.
Unlock the spray gun trigger.
7.
Slowly turn the pressure control knob clockwise to the maximum setting (5).
Turn the PRIME/SPRAY knob to SPRAY.
Point the spray gun at a piece of scrap material/cardboard.
Pull the trigger and practice spraying (see pages 13-14).
Motor will cycle ON and OFF while spraying to regulate pressure.
i
This is normal.
5
12
6
OR
OR
EN
1
2
3
4
7
SPRAY
PRIME
SPRAY
PRIME