Check For Suction - WAGNER CONTROL PRO 190 Manual Del Propietário

CHECK FOR SUCTION

Priming your pump is first step to getting ready to spray. Do a quick check to make sure there is suction as the
i
valves can stick for various reasons. There are a few tricks Professionals use to make sure the sprayer primes
without trouble at the beginning of every use. Follow the steps below or watch them in action at:
www.wagnercontrolpro.com/howto.
YOU WILL NEED
•
Mallet
•
Water
•
Extension cord
FIGURE 1: CHECK FOR SUCTION
1.
Remove suction tube if attached.
2.
Press red pusher stem 3-4 times.
3.
Turn PRIME/SPRAY knob to PRIME. Switch unit on and put your
finger over the inlet opening.
• If you feel a light suction, your pump is ready to use. Shut the pump
OFF (0).
• If not, shut the pump OFF (0) and perform the steps below.
FIGURE 2: TAP THE OUTLET
1.
Attach the spray hose to the outlet port.
2.
Tap the outlet valve / spray hose connection a few times with a
mallet.
3.
Switch unit ON and set the PRIME/SPRAY knob to PRIME.
4.
Put your finger over the inlet opening once again.
• If you feel a light suction, your pump is ready to use. Shut the pump
OFF (0).
• If not, shut the pump OFF (0) and perform the steps below.
FIGURE 3: USE WATER TO FREE THE OUTLET VALVE
1.
Make sure pump is switched OFF and suction tube still not connected.
2.
Carefully turn the unit over.
3.
Pour a small amount of water (1-2 oz.) into the inlet opening.
4.
Press red pusher stem 3-4 times.
5.
While unit is flipped over, turn the unit ON. The water should be
sucked in and come out of the outlet port. Shut the unit OFF. Note:
After every use, this procedure should be repeated with some
light household oil. See "Long Term Storage" section in the
instruction manual.
FIGURE 1
3 - 4X
FIGURE 2
TAP WITH A MALLET
FIGURE 3
3 - 4X
EN
WATER
(1-2 OZ)
7