7.
Attach the filter housing to the spray gun by threading it through the
hole in the restraint and into the bottom of the spray gun body as shown.
Tighten with a wrench.
8.
Thread the end of the hose into the bottom of the filter housing assembly.
Spin the swivel to tighten the gun to the male fitting of the spray hose.
Do not kink the hose when attaching it to the gun.
Attention
9.
Slide the suction tube onto the inlet valve. Secure with the suction tube
clamp.
10.
Press the return tube onto the return tube fitting. Squeeze hose clamp
over the return tube fitting to secure the return tube.
10
EN
ASSEMBLY (CONTINUED)
7
8
9
9