ENGLISH
USE
WARNING!
On some points of the machine there are some adhesive plates indicating:
–
DANGER
–
WARNING
–
CAUTION
–
CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates.
Do not cover these plates for any reason and immediately replace them if damaged.
BEFORE START-UP
9
Brush installation
NOTE
The machine is supplied with two brushes (A, Fig. 2) installed. According to the type of fl oor to be cleaned, the brushes
can be replaced.
1.
Lift the machine by prying the handlebar (2).
2.
Install the brushes (A, Fig. 2) in the 2 hubs of the deck (9).
3.
Lower the machine by using the handlebar (2).
10
18
14
1
12
A
Figure 2
2
3
9
A
Operator's Manual - Vantage 13
P100308
P100313