Troubleshooting Guide; Fault Symbols - Migatronic OMEGA 3 YARD 300 Manual Del Usuario

Troubleshooting Guide

Error Cause and solution
code
E20-00 There is no software present in the control
E20-02 unit
E21-00 Download Omega software to the SD card,
E21-06 insert the SD card into the control unit and
E21-08 turn on the machine. Replace the SD card,
if necessary.
E20-01 The SD card is not formatted
E21-01 Format the SD card in a PC as FAT and
download Omega software to the SD card.
Replace the SD card, if necessary.
E20-03 The SD card has several files of the same
E21-02 name
Delete files on the SD card and reload
software.
E20-04 The control unit has tried to load more
data than there is room for in the memory
Reinsert the SD card or replace the SD card.
If this does not solve the problem, contact
Migatronic Service.
E20-05 Software on the SD card is locked for
E20-06 another type of control unit
Use an SD card with software that matches
your type of control unit.
E20-07 The internal copy protection does not
allow access to the micro-processor
Reinsert the SD card into the machine or
contact Migatronic Service.
E20-08 The control unit is defective
E20-09 Contact MIGATRONIC Service
E21-05
E20-10 The loaded file is defective
E21-07 Reinsert the SD card or replace the SD card.
E21-03 The welding program package does not
E21-04 match this control unit
Use an SD card with software that matches
your type of control unit.
Err GAS Gas error
Check the gas supply.
Cancel the gas fault by briefly pressing any
key.
E02-04 CAN communication error
Check intermediary cable/plug
E11-20 Current sensor error
1. Check the current sensor
2. Contact MIGATRONIC service

Fault symbols

Temperature fault
The indicator is switched on, when the
power source is overheated.
Leave the machine on until the built-in fan has
cooled it down.
20