JVC KD-ABT22 Manual De Instrucciones página 14

4
Enter a PIN (Personal Identification Number)
code to the unit.
• You can enter any number you like (1-digit to
16-digit number). [Initial: 0000]
• To enter a PIN code less than 4-digit, firstly
delete the initial PIN code (0000) by pressing
number button 5 (
* Some devices have their own PIN code. Enter the
specified PIN code to the unit.
1
Move to the next (or previous) number
position.
2
Select a number.
3 1
Repeat steps and
entering a PIN code.
4
Confirm the entry.
5
Operate the target Bluetooth device, (while
"Open..." is flashing on the display).
On the device to be connected, enter the same PIN
code you have just entered for this unit.
"Connecting..." flashes, then "Pairing Ok" or
"Connected [Device Name]" appears on the display
when the connection is established. Now you can
use the device through the unit.
appears when the connection is established.
14
).
2
until you finish
The device remains registered even after you
disconnect the device. Use "Cnnct Phone" or
"Cnnct Audio" (or activate "Auto Cnnct") to
connect the same device from next time on. (See the
following and page 36.)
Deleting a registered device
Perform steps 1 and 2 on page 13, then...
1
Select "Del Pairing."
2
Select a device you want to delete.
3
Delete the selection.
• Press number button 3 to select "No" or return to
1
step .
Connecting a registered device
Perform steps 1 and 2 on page 13, then...
1
Select "Cnnct Phone" or "Cnnct Audio."
2
Select a device you want.
"Connecting..." flashes, then "Connected (and
device name)" appears on the display when the
device is connected.