Tabla de contenido
Publicidad
Terminology
Back light key : when activated, all keys will be lighted up
1
and visible in the dark.
ADJ. : ADJUST key, to enter the adjustment mode or for
2
quick exit in the adjustment mode.
A ddress key (sunk key), to enter the address of the projec-
3
tor (between 0 and 9). Press the sunk address key with a
pencil, followed by pressing one digit button between 0 and
9.
STBY : stand by button - to start projection when the
4
power switch is switched on.
without switching off the power switch.
PAUSE : to stop projection for a short time, press 'PAUSE'.
5
The image disappears but full power is retained for imme-
diate restarting.
Digit buttons : direct input selection.
6
Picture controls : use these buttons to obtain the desired
7
picture analog level (see also 'Controlling').
PHASE : used to remove the instability of the image.
8
TEXT : when adjusting one of the image, e.g. controls
9
during a meeting, the displayed bar scale can be removed
by pressing 'TEXT' key first. To re-display the bar scale on
5975646S BARCOGRAPHICS 8100 161296
- to switch off the projector
Ubicación y Función de los Mandos
the screen, press 'TEXT' key again. 'TEXT' key only active
in operational mode.
FREEZ : press to freeze the projected image.
10
ENTER : to start up the adjustment mode or to confirm an
11
adjustment or selection in the adjustment mode.
EXIT : to leave the adjustment mode or to scroll upwards
12
when in the adjustment mode.
Control stick key (on RCU) or '+' and '-' keys (cursor
13
keys): to make menu selections when in the adjustment
mode.
The control stick can move forward, backward, to the right
or to the left.
Comparision between control stick movement and the use
of the cursor keys on the local keypad :
RCU
control stick forward
control stick backward =
control stick to the right =
control stick to the left =
Use the '+' and '-' keys (cursor keys) : to increase or
decrease the analog level of the image controls when they
are first selected.
RC operating indication : lights up when a button on the
14
remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
=
local keypad
=
'+' key up
'-' key down
'+' key right
'-' key left
5-5
Publicidad
Tabla de contenido
