Sennheiser Freporre Instrucciones De Uso página 25

freeport_514013_0808_Sp5.book Seite 7 Freitag, 29. August 2008 12:08 12
Connecting the microphone/instrument cable
The audio input is designed for the connection of both the ME 2 clip-on
microphone and instruments (e.g. guitars).
Connect the 3.5 mm jack plug from the microphone/instrument
cable to the 3.5 mm jack socket ».
Check the setting of the
to switch between microphone and instrument operation. If
necessary, readjust the setting.
Use the GAIN control
the receiver receives a good audio signal (no distortion and no
background noise).
Attaching and positioning the microphone
Use the microphone clip to attach the ME 2 clip-on microphone to
clothing (e.g. tie, lapel). Conduct the microphone cable so that noise due
to friction is avoided and make sure that the antenna and the cable do
not cross. The omni-directional microphone picks up sound equally from
all directions. However, it should be attached as close as possible to the
sound source.
Attaching the bodypack transmitter to clothing
Use the supplied belt clip
clothing. Make sure that the antenna is at least 1 cm away from the
body and is not kinked.
Switching the bodypack transmitter on/off
Press the ON/OFF button
or off. If the bodypack transmitter is switched on, the red LED
lights up.
Note:
Remove the battery when the transmitter will not be used for
extended periods of time.
Selecting and changing a channel
Switch off the transmitter before you change the channel.
Use a small screwdriver to set the channel selector switch
desired channel. You can switch between four different channels.
When you switch on the bodypack transmitter again, it will transmit
on the new channel ("Selecting a channel").
MIC/INST slide switch
¾
to adjust the transmitter sensitivity so that
¸
to attach the bodypack transmitter to
³
to switch the bodypack transmitter on
²
which allows you
·
º
to the
7