Stopping The Engine; Checking The Clutch - Garland FOREST 1220 Manual De Instrucciones

English
5. Pull the start up rope until the engine starts or it
makes one explosion.
6. Push the choke lever downwards. (Normal
operating position).
7. If the tool has not started, pull the starting rope
again (6) until it starts.
8. Leave the engine to warm up for a few minutes
before using the machine
6.4.2. STARTING UP WITH THE ENGINE WARM
If the machine is hot, put the switch (I), make sure the
choke is stuck and pull the starter rope until engine
starts. If after a few attempts the machine will not
start follow the steps starting with a cold engine.

6.4.3. STOPPING THE ENGINE

the ignition switch (1) to the STOP position (0).

6.4.4. CHECKING THE CLUTCH

After starting up and the engine is hot, the
chain must not be moved if the engine is
idle
If the chain turns with the engine running and without
accelerating, it will be necessary to regulate the idling
regime of the engine. To do this, turn the carburetor
nut "T" until the engine stops. If you are unable to
regulate the idling regime to stop the chain, because
the engine stalls, please contact the customer service
for help.
Release the throttle lever
and leave the engine
running idle for thirty
seconds.
Stop the engine by moving
The regulation of the screws (H) and (L)
must only be carried out by an offi cial
technical service.
6.4.5. CHECKING THE OIL SUPPLY
fl ow use a screwdriver and turn the screw either
left or right to increase the fl ow "MAX" or diminish it
"MIN". The words "MAX" and "MIN" are to be found
under the tool.
Ensure the oil reservoir is topped up every time fuel
is added.
6.4.6. PROTECTION AGAINST KICKBACK
Kickback is the most important danger of
these tools.
This tool is equipped with an automatic brake which
stops the chain turning if there is kickback while the
work is being carried out.
6.4.7. CHECKING THE SAFETY BRAKE
Put the engine at full power during 1-2 seconds and
push the brake lever forwards. The chain should
immediately stop while the engine is still running.
36/124
After starting the engine,
accelerate in order to move
the chain at an average
speed and check that the oil
is dispersed as shown in the
diagram.
The oil fl ow can be adjusted
with the oil fl ow regulator (1)
located in the top part of the
chainsaw cover.
In order to regulate the oil