Technical Data - Hilti SR 30 Manual Del Usuario

3.2 Intended use
The product described is a reciprocating saw. It is designed for cutting wood, wood-like materials, metals
and plastics.
The product is designed for two-handed operation.
3.3 Possible misuse
▶ Do not use the power tool to cut bricks, concrete, cellular concrete, natural stone or tiles.
▶ Do not use the product to cut pipes containing liquids.
▶ Do not saw into unknown materials.
3.4 Items supplied
Reciprocating saw, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group.
4

Technical data

For details of the rated voltage, frequency, current and input power, refer to the country-specific type
identification plate.
If the device is powered by a generator or transformer, the generator or transformer's power output must be
at least twice the rated input power shown on the rating plate of the device. The operating voltage of the
transformer or generator must always be within +5 % and -15 % of the rated voltage of the device.
Weight in accordance with EPTA procedure 01
Stroke rate
Stroke length
Blade holder
4.1 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Sound power level (L
WA
Uncertainty for the sound power level (K
Sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration
Vibration emission value for sawing chipboard (a
Uncertainty sawing chipboard (K)
16 English
)
)
WA
)
pA
)
pA
)
h,B
2243029
*2243029*
SR 30
4.8 kg
2,650 /min
32 mm
1/2 in
SR 30
98.1 dB(A)
3 dB(A)
78.1 dB(A)
3 dB(A)
SR 30
13.6 m/s²
1.7 m/s²