Assembly; Unpacking And Checking Contents - Bosch CM8S Instrucciones De Funcionamiento

BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 10
Unpacking the Miter Saw – When removing this tool
from packaging materials, reach down to the two side
carry-handle locations and slowly lift until it clears the
package.
WARNING
any component of the mechanism support
system.
Checking Contents in package – Open the top of
the package and look for the included loose parts.
Refer to the diagram below.
Loose Parts - 1 of each shown
Workpiece Clamp
Dust Bag

Assembly

Unpacking and Checking Contents

To avoid severe pinching, never
lift or move this saw by gripping
To avoid possible injury, always
WARNING
disconnect plug from power
source before
adjustments or repairs.
Check off for each part
Auxiliary Clamp Hole
Screws for Auxiliary
Clamp Hole
10.
performing any assembly,
Manual
Operating/Safety Instructions
5mm Hex Key