Amica 10143.4TdDpHaQaXSp Manual De Instrucciones página 54

OPERATION
To deactivate the alarm press any button
or turn oven function selector knob to „0" or
operate the control knob
is finished, current time is displayed along
with the selected oven function.If you wish
to activate the ECO function for a given oven
function but (Cook Time) or
Time) and (End Time) has not been set,
an extended acoustic signal is sounded and
symbol is flashing (for approximately 0.3
seconds) to indicate that the ECO function
cannot be activated for the selected oven
function or input data is not sufficient.
ECO function is only available if
Time) is set to at least 10 minutes. If meat
temperature probe is connected, its set tar-
get temperature must be at least 3°C higher
than current temperature. ECO function is
deactivated automatically if
or meat probe target temperature has been
changed and is lower than the required
minimum values. ECO function is also deac-
tivated in the event meat temperature probe
causes an error.
The set (Cook Time) or
and (End Time) are irrelevant when
cooking using the probe. In this case press
the button last after oven chamber tem-
ECO
perature and meat probe temperature have
been set.
. Once cooking
(Cook
(Cook
(Cook Time)
(Cook Time)
54
5.4 Aqualytic function
Cleaning of the oven chamber with steam.
Pour 50 cl (two glasses) of water at the bottom
of the oven chamber. Close the oven door.
To activate the Aqualytic function press
The symbol is flashing. The temperature
is set automatically and
set to 00:30). Cook time and temperature are
shown on the display. Oven graphic symbol
is flashing indicating the recommended oven
function . Set the function selector knob
as recommended. Electronic programmer
confirms the correct setting by a short aco-
ustic signal and
recommended oven function is not set within
10 seconds, Aqualytic function is deactivated.
Temperature set for the Aqualytic function
is 90°C.
To deactivate the Aqualytic function press
button or operate the oven function
CLEAN
selector knob. Once the Aqualytic function
is deactivated, electronic programmer will
switch to normal mode of operation (normal
cooking settings).
An acoustic signal is sounded (4 beeps - a
pause - 4 beeps) after the initially set time has
elapsed. The sequence of acoustic signals
is repeated for approximately one minute in
three second intervals. "00:00" is displayed
and the symbol is flashing.
To deactivate the alarm press any button
or turn oven function selector knob to „0" or
operate the control knob. Once the process
is finished, current time is displayed.
(Cook Time) is
. symbol is shown. If the
.
CLEAN