Preset Programmes - Amica 10143.4TdDpHaQaXSp Manual De Instrucciones

OPERATION

5.6 Preset programmes

Preset programmes incorporate ready co-
oking recipes. Preset programmes combine
a given oven function or a number of oven
functions with a suitable cook time, which
depends on food weight to be cooked.
IOperating instructions will indicate which of
the preset programmes can be used to cook
a given type of food. To activate a preset pro-
gramme, press
knob is in "0" position.
and "P01" is displayed. You can change the
preset programme by operating the control
knob . . If the selected preset programme
requires the use of temperature probe and the
probe is disconnected or if the programme
does not require the use of temperature probe
and the probe is connected, then the probe
symbol is flashing.
To confirm selection of the preset programme,
press , button; a short acoustic signal
is sounded to indicate correct temperature
probe connection and readiness for the next
stage. If is not pressed within 10 se-
conds, the programme will be cancelled. If the
selected programme requires entry of cooked
food weight, then weight value flashes on the
display. Weight can be changed by operating
the control knob
the programme, press
beep is heard. If
seconds, the programme will be cancelled. In
the right section of the display, oven graphic
symbol is flashing indicating the recommen-
ded oven function
For preset programmes which do not require
the use of temperature probe, Cook Time and
set temperature are shown on the display. For
preset programmes which require the use
of temperature probe, current time and set
probe temperature are shown on the display.
, when function selector
(recipe) is flashing,
.To confirm selection of
, button; a short
is not pressed within 10
Set the function selector knob
function recommended by the programme.
Electronic programmer confirms the correct
setting by a short acoustic signal. Cook time
and temperature are shown on the display.
For programmes which require the use of
temperature probe, current probe tempera-
ture is displayed when the main programme
is started. If the recommended oven function
is not set within 10 seconds, the programme
will be cancelled.
To check programme settings, press
any time during preheating or during the main
programme. Programme number and weight
(where applicable) are displayed for programs
which do not require the use of temperature
probe or programme number and the set
probe temperature. In this case, however,
it is not possible to change these settings.
To change the settings, end the programme
and reset it. When programme settings (Cook
Time, temperature, probe temperature) are
changed when preset programme is in use,
the symbol
To cancel the programme, operate the oven
function selector knob.
56
goes out.
on the
at