Metabo HPT DH 18DSL Manual De Instrucciones página 15

Mounting hole
Side handle
6. How to use the drill bit (taper shank) and the taper
shank adapter
(1) Mount the taper shank adapter to the rotary hammer.
(Fig. 15)
(2) Mount the drill bit (taper shank) to the taper shank
adapter. (Fig. 15)
(3) Turn the switch ON, and drill a hole to prescribed
depth.
(4) To remove the drill bit (taper shank), insert the cotter
into the slot of the taper shank adapter and strike the
head of the cotter with a hammer supporting on the
rest. (Fig. 16)
Drill bit
Taper shank
adapter
Cotter
Depth gauge
Fig. 14
Grip
Front cap
Fig. 15
Taper shank
adapter
Rests
Fig. 16
7. Switching between the "SAVE" and the "POWER"
modes
The hammering force of the hammer can be increased
or decreased to conform with intended usage, by
operating the shift knob as per Fig. 17.
Adjust the force to match the usage intended.
Shift knob
(1) "SAVE" mode ... decreased hammering force
This can prevent thin drill bits which are less than
4.3 mm in diameter, from being bent or broken.
(2) "POWER" mode ... increased hammering force
○ This can be used to speedily and effi ciently drill holes
when the drill bits which are being used are greater
than 4 mm in diameter.
○ This can be used to drill holes into wood or metal.
CAUTION
Do not drill holes in wood with the "SAVE" mode.
There is a likelihood that the motor will burn
out because it can easily lock up due to the low
power.
8. About Remaining Battery Indicator
When pressing the remaining battery indicator switch,
the remaining battery indicator lamp lights and the
battery remaining power can be checked. (Fig.18)
When releasing your fi nger from the remaining battery
indicator switch, the remaining battery indicator lamp
goes off . The table 6 shows the state of remaining
battery indicator lamp and the battery remaining
power.
English
"SAVE" mode
"POWER" mode
Fig. 17
15