Vci Manager Program; System Requirements - Bosch MTS 6531 Instrucciones De Manejo

en 10 | MTS 6531 | Product description
4.7.2 Power Supply
The MTS 6531 is designed for voltage to
be supplied from the vehicle via the diagnostic
connection cable. For data transfer or a sys-
tem update, the MTS 6531 can also be
supplied with voltage from the USB port on a
computer.
i
If the is MTS 6531 to be configured
for a wireless connection, the voltage must
be supplied via the USB connecting cable.
4.7.3 LED status display
Four light emitting diodes (LEDs) are located on
the front of the MTS 6531. The LED indi-
cators provide the following status information.
Icon Color LED Function
Status
MTS 6531 without er-
green
rors
Error occurred, perform a re-
red
set
MTS 6531 connected
green
to vehicle
Flashing Not connected to external 12
red or 24 V power
MTS 6531 without er-
off
rors
Error occurred or
red MTS 6531 in reco-
very state
MTS 6531 not connec-
off
ted to a computer
Flashing MTS 6531 connected
green to computer
MTS 6531 off
off
MTS 6531 on
green
yellow/ depending on user software
green
yellow/ depending on user software
green
|
1 689 989 445 2019-07-01
4.8

VCI Manager program

The "VCI Manager" program is a host compu-
ter application which runs on the Windows
operating system to configure and update
MTS 6531. The software "VCI Manager"
allows the configuration of VCI-to-host computer
communications and facilitates VCI firmware
updates.
4.9

System requirements

The MTS 6531 is set up and updated
via the "VCI Manager" software. VCI Manager is
installed on a computer. The MTS 6531 is
controlled in the corresponding user software.
i
The system requirements listed below refer to
use of the "VCI Manager" software. The user
software requirements may differ.
R
Windows 7, Windows 8 or Windows 10 (32-
bit and 64-bit)
R
100 MB free hard disk space
R
512 MB RAM
R
1 GHz processor
R
1 free USB ports
R
1024x768 display resolution
Robert Bosch GmbH