Sony NSA-PF1 Manual De Instrucciones página 17

Troubleshooting
If you experience any of the following difficulties while using the
system, use this troubleshooting guide to help remedy the
problem before requesting repairs. Should any problem persist,
consult your nearest Sony dealer.
No sound is output from the system.
The power of the system is off.
 Check the power of the system.
Playback component is not connected correctly.
 Check that the component is connected correctly.
Volume of the system is low.
 Check the volume of the system.
Input source of the system is not selected.
 Select the input of the system correctly.
The settings on a digitally-connected component is not set to
Linear PCM.
 Check that a digitally-connected component is set to Linear
PCM.
There is hum or noise.
Playback component is not connected correctly.
 Check that the component is connected correctly.
Audio components are placed near other components that are
causing noise (TV set, etc.).
 Place the audio components farther away from the TV set, etc.
Color irregularity occurs on TV monitor.
 Place the system farther away from the TV set.
Three INPUT SELECT indicators flash at the same time.
 Turn off the system, unplug the AC power cord (mains lead), and
then consult your nearest Sony dealer.
Specifications
Speaker system
Speaker unit
Enclosure system
Frequency range
Inputs
Analog
Digital
General
Power requirements 220-240 V AC, 0/0 Hz
Power consumption
Dimensions (approx.) 2 mm × 1,84 mm × 2 mm (w/h/d)
Mass (approx.)
Supplied accessories AC power cord (mains lead) (2)
Design and specifications are subject to change without notice.
 way active speaker
Woofer: 1 cm cone type, Mid range: 7 cm cone
type, Tweeter: organic glass type
Bass reflex
0 Hz - 20 kHz
Line (pin jack L/R)
COAXIAL (pin jack), OPTICAL (TOS),
Linear PCM 2 ch (2, 44.1, 48,  kHz/1 bit,
24 bit)
8 W
0. W (standby mode)
12. kg
Cleaning cloth (1)
Remote control (1)
R0 (size AAA) batteries (2)
Operating Instructions
17