Playback In S-Vhs Et Format - Sony SVT-S480ES Manual De Instrucciones

Playback in S-VHS ET Format

This VCR is equipped with S-VHS ET format, so that
when you play back a tape, the VCR automatically
detects the S-VHS ET format and gives you a high
quality picture.
You can set to activate this function on the GENERAL
SET menu.
1
1
Turn on the power of the equipment to be used.
2
Press MENU and MENU V until "4" of the MAIN
MENU flashes on the monitor screen.
< >
MAIN MENU
1. LANGUAGE
CLOCK SET
DAYLIGHT SET
2. DISPLAY SET
BUZZER
SW OUT
3. ALARM SET/1SHOT REC
4. GENERAL SET
5. TIMER SET
6. HOLIDAY SET
7. POWER FAILURE/DEW
USED HOUR
8. ALARM DATA
SELECT : NEXT : RETURN : MENU
3
Press MENU B.
The GENERAL SET menu appears.
GENERAL SET
REC MODE SP
TAPE T–120
TAPE IN MODE STOP
TAPE END MODE REW
TAPE USED COUNT OFF
CLOCK ADJUST 0 1 : 0 0
APC ON
THREAD CHECK OFF
T/D SEARCH CONVENTION
PB S–VHS AUTO
BAUD RATE 1 9 2 0 0
<NEXT PUSH >
+
–
SELECT : DATA SET : / RETURN : MENU
4
Press MENU V to move the flashing to the setting
of PB S-VHS.
2-5 6
5
Set to AUTO or OFF by pressing MENU + or –.
AUTO: the VCR automatically detects S-VHS ET
format and plays back the tape (normally set to
this mode).
OFF: the VCR plays back tape using VHS format.
When a tape recorded using VHS format is
played back, if the picture becomes noisy, set
PB S-VHS to OFF.
Note
When the tape is ejected, the setting returns to AUTO.
6
Press SEARCH/AUDIO ON to return to the
normal display.
To return to the MAIN MENU screen from the
current menu
Press MENU again.
To go to the next menu from the current menu
Press MENU V until "NEXT PUSH B" flashes and
press MENU B.
49