Fault Finding; Spare Parts List - SKF TMBH 1 Instrucciones De Uso

5.1 Fault finding

In case of certain malfunctions, the operator will be guided by an error code appearing on
the display:
Display Fault
E 00 E Electronic failure
E 01 E Electronic failure
E 02 E Electronic failure
E 03 E Overheating in housing
E 04 E Selected time / temperature
out of range
E 05 E Temperature increase below
1 degree per 15 s.
E 06 E Temperature probe not connected
or defect
E 07 E Temperature above 200 °C (392 °F)
E 08 E Clamp is open
E 09 E Clamp not plugged in or broken
6

Spare parts list

Designation Description
TMBH 1-1 Control box (complete)
TMBH 1-1A Logic print
TMBH 1-1B Power print
TMBH 1-1D Housing cover (including keyboard foil)
TMBH 1-1E Keyboard foil
TMBH 1-1F Mains inlet connector (female Euro-connector)
TMBH 1-1G Main switch
TMBH 1-2 Heating clamp (including cable and plug)
TMBH 1-2A Heating clamp plug set (male and female part)
TMBH 1-3 Temperature probe (including cable and plug)
TMBH 1-3A Temperature probe plug set (male and female part)
TMBH 1-5 Heating pad
MP524 Instruction manual
WORLDWIDE PATENTS
SKF TMBH 1
Action
Return to SKF for repair
Return to SKF for repair
Return to SKF for repair
Wait for unit to cool down
Adjust time / temperature
setting
Check that the probe is properly
attached to the workpiece or
change to TIME MODE
Check the probe
Stop heating
Close the clamp
Plug in or change the clamp
9