Battery Installation - Arregui SUPRA Manual De Instrucciones

<EN>
IMPORTANT:
The first opening of the safe you must use
the emergency key:
• Access the emergency lock.
• Introduce the emergency key and turn it
clockwise.
NOTE: Do not store the emergency key inside the safe

1. BATTERY INSTALLATION

Open the plastic cover located inside the door and place 4 1.5 V AA
batteries.
2. PROGRAMMING THE OPENING CODES
This safe allows to program two secret opening codes--one standard and
one master, from 3 to 6 digits each.
The initial standard code is 000000 and the initial master code is
888888. For your security, it´s important that you change them and
configure the codes you desire.
During the process, use the
Programming the standard code (the safe must be open):
A. Press 00 and the
B. Press the 0 button. The screen will display SET.
C. Enter your code (3 to 6 digits) and press the
will display DONE.
With the door open, verify that the new code operates correctly (see
section 3, opening the safe).
Programming the master code (the safe may be open or closed):
A. Press 00 and the
B. Press the 1 button. The screen will display OLD.
C. Enter the current master code (888888 the first time) and press
the button. The screen will display SET (if the code entered is
incorrect, it will display ERROR).
D. Enter the new master code (3 to 6 digits) and press the
The screen will display REPEAT.
E. Enter the new master code again and press the
screen will display DONE (if the code entered is not the same both
times, the screen will display ERROR).
3. OPENING THE SAFE
Enter either of the two active opening codes and press the
The screen will display OPEN while the locks move, and OPENED when
the door has opened, and inside LED lamp will bright 25 seconds
automatically.
button to delete the last digit entered.
button. The screen will display SELECT.
button. The screen will display SELECT.
- +
EMERGENCY
LOCK
button. The screen
button.
button. The
button.