Radio Operations; Listening To The Radio; Searching A Station Automatically: Auto Search - JVC KD-SH9750 Manual De Instrucciones

RADIO OPERATIONS

Listening to the radio

You can use either automatic searching or manual
searching to tune in to a particular station.
Searching a station automatically:
Auto search
1
Select the band (FM1 – 3, AM).
1 Press SRC (source)
SRC
2 Press and hold SRC for more
AM
FM1
3 Within about 5 seconds (while
FM3 FM2
Last received station of the selected band is tuned
in.
If a name has been assigned to the station (see
page 44), the assigned name appears.
Lights up when receiving an FM stereo broadcast
with sufficient signal strength.
10
D
SRC
DISP
ATT
SEL
repeatedly to select the tuner.
than 1 second.
The band indication on the
display starts flashing.
the band indication is
flashing), press SRC again.
Each time you press the
button, the band changes.
1 2 3 4 5
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to an
FM broadcast.
2
Start searching a station.
Ex. When the band is FM
When a station is received, searching stops.
To stop searching before a station is received,
press the same button you have pressed for
searching.
BBE
MODE
6 M
Press ¢
to search
stations of higher
frequencies.
4 to search
Press
stations of lower
frequencies.