dirna Bergstrom bycool COMPACT 1.4 Instrucciones De Montaje página 17

COMPACT 1.4
3
OUTSIDE CABIN:
Position Compact in sun hatch hole.
CAUTION! When positioning the unit above
the hatch gap, check that the wastewater
run-offs are not blocked by the EPDM seal.
4
CABIN INTERIOR:
Thread 5 mm approximately (4) studs 6/100x100
in the base of the Compact.
From point 5 up to point 10 the operations carried
out are to align the Compact, which is why there
is no full tightening.
5 Position (1) rubber washer Ø 6, (1) wide flanged
Ø 6 flat washer, (2) M6 nut and (1) wide flanged
Ø 6 flat washer, in each one of the previous
studs.
Air conditioning for vehicles
17
Sun hatch
4
4
5
5
EN
3