dirna Bergstrom bycool INTEGRAL POWER Instrucciones De Montaje página 8

EN INTEGRAL POWER
Assembly
Recommendations
• Before starting assembly, please read instructions
and follow them during installation process.
• Use the adequate tools for each operation.
Electricity
• Disconnect ignition key.
• Disconnect battery before starting assembly.
• Make sure electric components are securely
connected, checking their correct fitting.
! Warning
When installing air conditioning equipment on roof, the
upper cabin part must be protected with a cloth or a
protective blanket to avoid possible scratches. When
installing Integral Power on roof, take into account that,
normally, cabins equipped with a hatch have a strong
enough structure to hold equipment weight. However,
if it is not the case and it is necessary to carry out a
cut in the roof or, although it has a hatch, the material
is not resistant enough (if roof is made of fibre, plastic,
etc...), it is the installer who will have to decide, under
his responsibility, if it is necessary to reinforce the roof to
avoid possible deformations, breaks, water entries, etc.,
habilitating the means required to stop it from occurring.
Torx wrenches set
Allen wrenches set
Open-jawed spanner 10
Scissors
Flexo-meter
Ø10 Wrench
Phillips screwdriver / screwdriver
Ø35 Circular saw
Ø7 Drill
Sabre saw
Documentation included
Mounting instructions
User's guide
Troubleshooting
Warranty
!
The installing personnel must have a sufficient
training in vehicles air conditioning.
!
dirna Bergstrom, s.l. shall not be responsible for
breakdowns or damages coming from an inadequate
handling or installation of the equipment or from
modifications and substitutions carried out without
our express and written authorisation.
!
Unit pre-loaded with refrigerant gas R-134a, (
I.P. 12 V. 500 g. - I.P. 24 V 500 g ) (Do not touch
the refrigerant gas circuit).
!
Please see product warranty procedure included in
Troubleshooting.
!
Please see equipment User's Guide for its correct
functioning of the remote control and control panel.
!
Once installation is finished, the following documents
must be handed over to the user: User's Guide,
Warranty and Troubleshooting.
8
Tools
220AA65031
220AA21001
220AA21002
220AA10010
! Warnings
®