Working With Time Control - Time Mode - SKF TIH 240 Instrucciones De Uso

«БЕРГ АБ», (495) 727-22-72, promshop-biz@ya.ru, www.promshop

3.2.2 Working with time control - TIME MODE

a) Select TIME MODE by pressing
b) Set desired heating time by using the keys
c) Press
d) Press
displayed.
e) When the pre-selected time has run out, the heater switches off after
automatically demagnetising the workpiece.
f) An acoustic signal will indicate the completed
heating cycle.
This will switch off after about 10 signals or when
g) The heater is again ready for use with the same pre-selected time.
«БЕРГ АБ», (495) 727-22-72, promshop-biz@ya.ru, www.promshop
10
when recommended according to paragraph 3.6.
to start the heating. The remaining heating time will be
.
- .
is pressed.
SKF TIH 240