Description; Components; Technical Data Tih - SKF TIH 240 Instrucciones De Uso

«БЕРГ АБ», (495) 727-22-72, promshop-biz@ya.ru, www.promshop

2. Description

The heating cycle is electronically controlled either in a TIME MODE,
where the heating time is selected, or in a TEMP MODE where the
desired temperature is selected. The temperature can be measured
either in oC or oF. The heater can further be run on 50% capacity when
small yokes are used or when there is a risk for too quick heating of
sensitive workpieces (e.g. bearings with C1 or C2 clearance).

2.1 Components

The induction heater consists of a U-shaped iron core with a large
induction coil on one of its legs. The control electronics sits in a separate
control box on top of the heater.
The temperature is controlled by means of a magnetic probe.

2.2 Technical data TIH 240

Voltage
Power consumption (maximum)
Recommended fuse
Temperature control
Time mode
Power reduction
Demagnetisation
Overall dimensions (w x d x h)
Standard yoke dimensions
Space between supports (w x h)
Coil diameter
Weight
«БЕРГ АБ», (495) 727-22-72, promshop-biz@ya.ru, www.promshop
6
TIH 240
TIH 240/460 V
:
2 x 400 V, 50 Hz
2 x 460 V, 60 Hz
:
24 kVA
:
63 A, slow blow type
o
:
0-250 C (32-482
:
0-60 minutes; in steps of 0,1 minute
:
50%
:
automatic; residual magnetism <2A/cm
: :
750 x 400 x 935 mm (30 x 16 x 37 in)
:
100 x 100 mm (4 x 4 in)
:
330 x 355 mm (12,9 x 13,9 in)
:
186 mm (7,3 in)
:
300 kg (660 lb)
o
F)
SKF TIH 240