Thermometer Mode; Change Of Temperature Unit; Demagnetisation - SKF TIH 240 Instrucciones De Uso

«БЕРГ АБ», (495) 727-22-72, promshop-biz@ya.ru, www.promshop

3.3 Thermometer mode

By pressing
the actual temperature recorded by the probe will be displayed.
Reset this function by pressing any other key.

3.4 Change of temperature unit.

To change from
be pressed simultaneously.
The last setting will be remembered.

3.5 Demagnetisation

The workpiece is automatically demagnetised at the end of the heating
cycle.
This function is eliminated when the heater is switched off by the
key, the main switch or by pulling the plug.
When using the heater for demagnetisation only, just run the heater on
shortest possible heating time.
«БЕРГ АБ», (495) 727-22-72, promshop-biz@ya.ru, www.promshop
12
and simultaneously when the unit is not running,
o o
C to F, or vice versa, the buttons and should
SKF TIH 240